Quote:
Originally Posted by SuperD
I removed the foil tape, used 3M spray adhesive, and filled in all the gaps with foil bubble wrap. Next I used my templates and cut the 3/4" DynaMat. By carefully aligning the templates I had leftover from using just one sheet, so don't order two. I closed up the seams with tape and then using the templates I cut the Dynaliner and stuck it in place. Since the sheets were smaller I had to use several small pieces but cut each to fit and left no gaps. I finished by using the tape to cover all the seams.
|
SuperD, which thickness Dynaliner did you use over top of the 3/4" Dynamat? I'm getting ready to do the same on our Axis.