Quote:
Originally Posted by ctpres
BigBen If thermal shutdown and not thermostat - it is not getting enough return air. To prove lift glass panel, remove screws and pull FP out a couple inches. Test operation to see if it still shuts down early. Dramatic improvement in heating and thermal shutdown can be done by A. pulling heater out 1/4 inch or so and drilling new screw holes. B. what I did - there is an enclosed shelf below countertop for electronics, with FP removed remove the rear wood panel to the electronics shelf. Just held on with a bunch of long staples. Creating an return air opening closer to the bottom of the FP would be better. I just could not figure out how.
|
Many thanks I figure it out for coach. Again thank you