Installing Trailer Brake

[Chateau29Z]

Recently I bought a Tekonsha brake controller. The Ford agency looked up the VIN on my chassis (2012 E-450) and said it was pre-wired and the plug was under the change holder in the top of the dash. Sure enough it was and the Tekonsha 3034-P cable and connector mated perfectly. I looked under the dash to find a place to mount the controller and found a similar plug (not identical) and when ringing it out found many parallel connections. I would like to disconnect this, or at least un-mount it to get the Tekonsha controller in a good spot. Does anyone have any idea what I am dealing with?
I am trying to post a photo of this, but don't see it in the message area.

 

[Thehobe1]

Call Thor

Especially if there are multiple plug ins.

 

[The Gritz Carlton]

Not clear what your outlining here but if you're talking removing a wiring harness for the space...I wouln't touch any wiring if everything is operating good in the coach. Moving something over...yes...cutting, splicing or removing...no.

 

[Chateau29Z]

Installing trailer brakes

The guy at Tekonsha Identified it as the OBD connector. I feel so stupid that I couldn't figure it out anyway I'm proceeding on without cutting any wires. Thanks for all your comments

 

[Chateau29Z]

Installing trailer brakes

The mystery plug is the OBD connector. I feel stupid for not recognizing it

 

[The Gritz Carlton]

The only stupid person is the one that does stuff anyway, knowing he doesn't know. At least he knows something.