Moisture in rear tail lenses

[4winds4me]

So I noticed I have moisture in both tail lenses 2019 Thor four winds, does Thor have a parts department ? I would like to order the gaskets. Thanks

 

[JamieGeek]

You are better off creating your own gaskets. The "gaskets" on the lights are cheap foam ones that crush when the lights are screwed on and allow water to enter.

When I replaced my tail lights with LED ones I used the foam gaskets as templates and cut out some rubber ones (rubber sheet purchased from The Home Depot).

I also sprayed the recesses for the lights with flex seal to prevent any moisture from damaging the wood.

 

[4winds4me]

Sounds like a great idea, so did you just replace the bulbs with LED’s now I’m curious , thanks

 

[JamieGeek]

Sounds like a great idea, so did you just replace the bulbs with LED’s now I’m curious , thanks

The taillights are made by a company called "Command Electronics" they make a replacement assembly with LEDs instead of lights. (I believe if you order it from them they will even include the wire harness for Thors making the swap out plug-n-play. I didn't and just spliced them in; still a pretty easy task.)

 

[axis earl]

Your Tail Lights

If you search for a thread on this issue you will find many comments, many pictures on replacing what you have with the Command Electronics LED lights. Even when you get the new LED lens you will get the same piece of garbage foam gasket. Many of us threw it in the trash and then use a roll of butyl rubber as a gasket and rubber O-rings with new stainless steel screws. Then, once installed, get some good RV all weather caulking around the outside of the fixture. Do tell Command Electronics that you have a Thor and they will get you the ones with the plugs that are ready to plug and play.