Slide Maintenance.

[Buddy-REDW]

I waxed both sides of all three slide today and the paste wax took the black marks off where the rubber seal had stuck. It actually just wiped right off. I also used Protect All Rubber Seal Treatment on all the seals except the top, I could not get to them with the toppers. I also used protect All Slide Out Dry Lube on the tracks on the bedroom slide and rails on the other two slides, I ran them in several time and they glide now. The wax helped as well I'm sure. Now I can't move, but it's done.

 

[Adamsvr]

I don't quite understand; however, if your slides don't move it probably involves the hydraulics. Check the 10amp fuse in the battery compartment. On the wiring on the right hand side about 1/2 way up in the back of the wiring harness you should be able to feel it. Check it out. Good luck.

 

[Buddy-REDW]

No problems, just did maintenance to keep everything working properly.

 

[Buddy-REDW]

Go figure cheap, easy and it works.

 

[hoosierguy]

Go figure cheap, easy and it works.

This is a great idea. Thanks for the link.

 

[Buddy-REDW]

I noticed my toppers must be working with the rain and dirt, they were clean on top of the slides.