I have a 2017 Palazzo 33.2.I’m looking for an answer if I did something or water heater just started. Friday got to camp spot plugged into power thru surge protector which said both legs had 124v, turned on electric side of water heater but cold water came out waited 20 mins no change. Then went to circuit breakers Flipped them off and back on wait 20 minutes still cold water. Saturday morning Turned waterheater to propane went to see if igniter would fire no glow no flame went battery box checked all breakers looked good then went into inverter compartment pulled 2- 5a fuses and 1 25a fuse in yellow circle they were good so I put back in. I then went to water heater pulled igniter wire off and saw 2 little red lights flashing check with multi meter for power ,yes . When I then went to reconnect igniter, flashed propane so then got igniter on water heater fired up after tank was hot switched back to electric everything worked fine for the rest of the weekend. My question is what where the fuses or could the igniter contact not good till I removed and replaced or just Coincidence.
