Thor Forums

[scrubjaysnest]

Originally Posted by davidgebo

It seems, oneilkeys, that you are re-engineering your Vegas just like I am. When I get our Vegas back from the shop for the 12th time, I will check the inner fenders. I have had to: re-hang the drawer slides properly, one screw per slide just wont do, tighten all the water connections, remove the tail-light assemblies, dry out the cavity, repair the already rotted plywood substrate, and re-seal the lights properly, re-caulk the shower wall panels, clean all the sawdust and woodchips from beneath the cabinet drawers, re-hang properly, the overhead cabinet door struts that all fell out because the pivot point was in direct contact with the cabinet wood with no washer or isolator to prevent the wood from abrading and the strut pooping off, attaching all the loose, hanging wiring beneath the coach with zip-ties. Some of the wires were abraded from contact with moving tires. I also had to adjust the front hood hinge assembly locking mechanisms, and lube the hinge hardware. The list goes on, I am afraid.

Still have to vacuum the debris left from the build, got most of the wiring done. Installed real battery hold down brackets instead of the straps I could never get tight.
Have to adjust the hood yet and install the clamps I picked up on Wed to clamp a dangling LP line.