JamieGeek

Hi Jamie,

Do you know what SumoSpring part# you installed in rear of axis? I have same axis 24.1 as you and want to make sure I get the correct one as there are a couple options.

Thanks

Hi thanks for your input about rv cover, you recommended an adco cover class c for a 2014 thor axis. class a.
will the 23 ft to 26 ft work? Or should I go bigger?
Thanks for you help?

i have a 25.2 2016 vegas. is it necessary to put stablizer on it to steer better ?? Thanks

Very poor reception tvs when using park cable, turned off the booster antenna. Have a THOR Freedom Elite 29 (2018) where can I find where the cable splitter is to check connections

Thanks Jamie!

Hi Jamie,

Seen a lot of dialogue on how best to install a battery disconnect switch (positive or negative)....can you advise how you installed yours - I am about to do my install. Just had a confusing situation with the breaker by the battery tripping and took out radio and generator and no other 12V systems so I was at a loss till I took it in to General RV...grrr!

Thanks for the reply Jamie. I had switched off the engine but didn't take the key out. I appreciate it. Do you have any tips for maintaining the slide?

Jamie; I ran across a new product today made by Texas Instruments. It is a 4 channel capacitive sensor, perfect for interfacing an arduino to a tank sensor:

https://create.arduino.cc/projecthub...fdc1004-9333c7

Digikey has the FDC1004s.

Hi Jamie, where have you had your chassis serviced locally? I contacted a Ford service center in Dearborn. I want to get the alignment done and steering stabilizer installed as soon as I take delivery.

Jamie:

If you could send me pictures of where on the frame and how the scissors jacks are mounted I'd greatly appreciate it. As I recall you had someone else mount them didn't you? You can send the pix to my email -- bevedfelker@live.com.

Thanks a lot.

Ed Felker