Thor Forums

[Porthole]

Originally Posted by Cummins12V98

Factory had the 3 panels stacked towards the rear of RV and textured side towards the inside and you had to reach around panels on the inside to latch. Real SMART!!!

They "CLAIMED" that's how the showers were sent to them. I really doubt the shower door was installed in the shower and sent to DRV. Been in Construction 35 years and NEVER seen that but who knows. In fact I guarantee you DRV installs them because my stall is 1/2" narrower at the top than the bottom.

By reversing it places EVERYTHING in it's proper position.

Well, mine is installed correctly - but the design allows water to splash out.
I cut the lip off the bottom of the track that allowed water to stay in the track, that helped. Still had water leaking out. Re-did all the sealant along the inside aluminum to fiberglass, still leaked. RE-did the globs of silicone in the corners of the track, still leaked.

Last night I stood outside the shower and sprayed the doors like I would normally when done with my shower. Spraying the outer door with the factory shower head and the onboard pump flows enough water to overwhelm the drains on the track, allowing to water spill over the side if you spray it long enough. And if you spray near that pull handle the water flows right around the handle and splashes out - 2" !

Looks like a shower rod and curtain will be necessary to keep all the water in the shower. Will be better then the towel we keep on the floor now to collect the water