Quote:
Originally Posted by awalk57
 I like your mods especially the 12 volt accessory panel. I am curious how did you install it and what 12 volt line did you access for power. I am thinking of using a similar setup for a small inverter to run fans or such. Is there a reasonable amount of power behind the panel? I would rather not have to run new lines to wherever I install the panel. |
I located the 12v panel in the vertical side face of the cabinet just forward of the entry door. On the bottom of the same cabinet are the switches for the overhead lighting, which are 12v powered.
I popped off the switch bezels and removed the mounting screws to allow the switch’s to drop down. I then removed the vertical inner panel of the cabinet mention above. This allowed me to route wires from the 12v panel I installed to the light switch location.
I identified the “hot” wire to the light switch and spliced into that wire as well as the associated ground wire.
Reinstalled everything and was good to go.
Note: I recently started a social group for Freedom Elite/ Four Winds owners to share mods, experiences etc.
You are welcome to join if you wish
http://www.thorforums.com/forums/gro...otorhomes.html
Thor Forums
