Quote:
Originally Posted by 16ACE27
I guess it depends on the size of your pool equipment:
Most pumps and gas heaters can be wired for either 120 or 240 VAC but a heat pump or electric heater would have to be 240 VAC.
|
I did some checking from afar because I am not at home, but it looks like my pool equipment has three 20 amp breakers in total. 2 of the 3 are connected together; so it
infers I do have 240 to the pool equipment. The stand alone 20 amp breaker must be for lights and controller? I will verify when I get back.
But for now, I will dump my plan to rewire my transfer switch to feed the pool equipment. If I can get all ten existing wired circuits in my Transfer Switch to be fed by my Onan 5500; I will be a Happy Camper while at Home, (pun intended).
If all this works, when/if my portable dies off, I may not need to replace it.
Thanks