Quote:
Originally Posted by mgianni
well I finally got the slide in and now should I try to sync it like in the manual. The directions say use the control to slide out and in an inch or two 3 times and then on the 4th slide it out and then it should sync
|
Did you check to see if the controller is flashing an error? If an error is being flashed the sync process may do no good and you may have to manually retract the slide again. If the controller is not flashing an error then you can try the sync process and that may solve your problem.
When I had my problem the error being flashed was for a disconnect between the controller and a slide motor and one motor was completely disconnected causing the slide to jam in a partially opened position.