Hi,
I just purchased a Weboost Drive 4G-X RV
https://www.weboost.com/products/drive-4g-x-rv
and am planning my install.
I will do a dry/test install first before drilling any homes.
I plan on the following install after dry testing.
-Install antenna on rear ladder rack.
-Drill hole in rear right side of ladder rack that will enter into storage bin.
-Install antenna wire through RV hole and seal with silicone caulk. I will loop the wire downward so water will not drain into hole as per Weboost directions.
-Install Weboost amplifier inside rear left storage compartment above bed.
-Splice power off of 12V LED light. The Weboost uses 8W, so at 12V its 0.7 Amps of power- much less than the fuse rating (which i think is 15A)
-Install interior antenna somewhere near booster. Maybe inside cabinet or outside depending on testing.
The biggest risk is when i drill through the RV and that I hit a power wire. I dont think there are any power wires located in that area- but I will drill a bit at a time and visually check.
Any comments/suggestions?
Thanks for the help