Slide issue AGAIN
Had a slide issue last week with only one motor working. Found a loose connection and it worked. We were repairing the slide COVER and it was necessary or run the slide in a Lttle and put a little several times. (I know your not supposed to stop and start part way). Now the slide is all the way out at both ends. The slide will start to come in from both ends and then one end stops! If I continue the other motor will continue and cock the slide. It's like the motor on the far end stops running. I think the motors are just OUT OF SYNC. Is there a way to Manually sync both motors with the slide all the way out???
PS: Lippett has a u-tube showing to run the slide in and out three times to sync but that is when the slide is cock a few inches. I tried the three times approach but dud nothing.
__________________
Jim K - Avenue, Maryland
2016 Thor Hurricane 35C
2015 Ford F-150 King Ranch
2013 Chrysler 300 "S", 1936 Chrysler C-8
2012 Jeep Liberty Limited Edition
|