Using the knowledge of the forum
So had my first experience with the Schwintek slide getting out of time . Put slideouts in when leaving CG , no issues . Arrived home , decided to wash and treat the roof and slide toppers , ran both slides out with no issues . 2 hrs later go to run the slide in , galley slide goes in perfect , bunk slide move about 8 " , then right side motor stops .
My heart skips a beat , then I remember all the time on this forum , just reading post and absorbing all the little nuggets of knowledge . So took a deep breath , did the out /in steps , took 6 times , but synced up just fine , ran the slide in and out 4 times with no issues . Just want to say Thanks to everyone on the forum .
__________________
|