Above The Shower Stall
in my ACE 30.2 is a strip of wall board, I’m guessing roughly 6-8 inches wide between the ceiling and the top of the shower stall, that gets really wet when I take a shower (one of the unfortunate side effects of being 6’5”). I’m assuming that Thor just used regular wall board here, with no type of water resistant backing like you’d find in sticks and bricks bathrooms. That being said, I was wondering if any of you wonderful folks have covered this area with anything to prevent it from getting wet? And if so, what did you use? I’ve already noticed the paper covering on the board beginning to slightly wrinkle and bubble. Not very noticeable right now, but I’d like to get ahead of it before any major problems begin. Thanks everyone!!
__________________
|