Quote:
Originally Posted by SunriseCamp
Hi, I've got a Thor Synergy 24MB. There is a circuit with a 15A fuse that supports USB outlets and lights on the left (driver's side) - with most of the outlets "inside the slide". I've blown this fuse multiple times when closing the slide.
I need some advice as to where to locate the wiring at the point where the wires transition from the stationary house to the slide. I'm guessing that I've got a wire being pinched.
Any ideas?
|
The LCI Schwintek In-Wall slide motors use 7-10 amps each at 14 volts. Recommended fuse is 30 amp (green) slow blow. I would advise never move the slide unless on shore power or generator power, as it significantly lowers the motors current draw.