Quote:
Originally Posted by starnje
I have the exact same problem on Hurricane 27k 2014. There is power at the bypass switch (12v) if the switch is actived but nothing at the connector of the steps. The wire go from the swith orange/white and should go to the connector of the step. At the step connector the wire is some sort of white . It looks like the wire goes trough some other connector to change color, but I can't find it. The wiring hardness from the switch goes from the passenger of the rv, reaches a bigger hardness on the driver side and then goes to ...I don't know. Then there is another hardness that goes form the driver side to the step connector. What happen in between I don't. The problem looks like a bad contact or a cut wire.
I assume the junction between the 2 connectors is done at the front of the rv as it should collect the ignition signal on a yellow wire but I can't confirm.
|
Further investigation reveal:
I was wrong wigh the wiring. The bypass switch signal goes all the way to the step without problem. I tested all of th wiring according to the manufacturer procedure and found the ignition signal to be good up to the connector, the door switch signal also good, the 12v power line good and as mentionned the bypass signal good. So it appears to be the control module. I will investigate further to see if the problem is the control box or in the wiring between the connector and the control box.