Thor Forums

[aa0ri]

I haven't found any threads on this subject so hope I'm not whipping a dead horse here.

I viewed the how to lubricate video on U-Tube covering the Lippert slide system and can't see how you can get into the inside to lube it.

The drive can't be reached through the gasket inside as you have to either reach all the way down the side of slide out if it's out or behind the inside flange if it's in. Possibly you could reach around the flange if the slide was not quite in but they say not to stop the slide before it reaches the end of travel. Lubing the outside of the drive was easy you can do the lower rail from the ground and the upper from a fairly short ladder.

I'd appreciate it if anyone who's done it would give me the secret.

Thanks, aa0ri