Quote:
Originally Posted by Beau388
Did you try to sync the motors? That requires the motors to be run to their limits (full up or full down) and the switch held in that position for 3 to 5 seconds. If you cannot get the bed fully up or down you can override the controller (instructions are on LCI website). Lots of trouble shooting available on the LCI site, also.
|
My Miramar 34.2 2015 had the same problem, so I took off the cover over the rails below the bed to find the motor gear was catching on a piece of vinyl covering in side the rail cover. I cut off the extra piece of vinyl so it could not get caught in the motor and realigned the 2 (L-R) elevation motors, now all is good.