Overhead bed drop solutions
The overhead bed in my Windsport 29M will not stay up. Bouncing down the interstates it always slips down a few inches even with the pins in. It vibrates so much that the pin holes elongate making it worse. Read somewhere that Thor recommends dropping it onto the pins so that it doesn't move but that creates a lot of noise and the controller starts throwing error codes because it gets out of sync. Then it becomes a pain trying to get it back in sync.
Thought that if I could find a way to anchor a nut plate where the pin mounts I could bolt it down. I haven't been able to find a suitable nut plate. Also considered some 2 x 4 braces that I could wedge in under the bed to hold it up.
What have others done?
__________________
|