|
Schwintek slide screws
Have a full side slide on my ACE. Word to the wise here. Check all the screws used to attach the gear brackets to the slide. There are about 8 or ten screws holding the two top brackets on both sides of the slide
If you haven’t done it, make sure they are all in tight. I had one start to back out which caused the slide to stop about 4 inches from full retraction. It bent the screw head, which made it a bitch to get out. Had to use manual override to get it closed. Probably will have to replace a motor soon. Making a grinding noise.
I think when I get to my next stop I’ll spend the whole day going over every screw, but and bolt I can find. Probably should have done that a year ago.
__________________
|
Thor Forums
