The answer is mostly yes. Your compressor should put out at least 10 cfm at idle. So a ratchet or even an impact gun to change tires on a toad would be no problem. An air stapler to put trim back on, no issue. I would not try to change tires on your coach. That may require a 1" impact at higher pressures. My last coach (gasser) required 450 ft. lbs. and whoever tightened them at the service center after the brake recall put them on so tight, I couldn't budge them with a 3' breaker bar with a 6' pipe on the end, even jumping up and down on it. Got them with my 1" impact at over 150 psi rated at 2000 ft lbs.
!
Mike