This is a pic of my door slide, lower corner by the door. The vertical corner comes from the factory with little more than masking tape to seal the corner under the corner molding. The clean tape to the left is my floor corner sealed with Eternabond tape. The bare area will be sealed with EB tape that will seal the corner. This project is now done on the door slide. I removed the corner moldings, sealed with EB tape and reinstalled the corners using caulked SS screws. Then rechaulked the moldings. 4 more slides to go.
__________________
George
Kerrville, Tx
2015 Mobile Suites 41RSSB4
2011 F350 Dually 6.7 PSD
|