So how does he stop the wear - does he attach a spacer around the cylinder?
Quote:
Originally Posted by Cummins12V98
My Machinist friend in WA just rebuilt my two front and two of the rears. The rears have QUALITY seals and he said they are vERY robust. Mine rears were leaking where the Glan screws onto the outer tube.
The fronts he went to a much better quality and type of seal as does Roberts.
It takes a pit to change out the fronts.
He also cuts off the foot pad adapter nut and welds on a new nut in alignment to the shaft. Lippert welds every one on crooked. Roberts does the same.
Roberts will replace the ram outer tube if the small return line is excessively worn at $200 ea. Problem is the wear will start all over again. My Machinist fried has came up with a way to keep the small tube from wearing against the inside of the silver outer tube you see. Another BIG improvement doing this upgrade the side to side stability is vastly improved!
Anyone thinking of doing this PM me. He is in NW WA.
|
Thor Forums
