Quote:
Originally Posted by DaveButcher1075
my bed room slide will only move 5" out or in before the motor stals. timed motors several times to no avail.
checked both harnesses and they look new no kincks pulled both motors and plugged them in seperately and they work. if I reset the the controller both motors work good until the flashing lights stop.
I have ordered to new harnesses and 2 new motors. The controller was replaced already.
the controller has 8 red flashing lights indicating electrical issue
has anyone experienced this issue?
|
That is usually a symptom of a frayed cable. The five wire cable runs down a chase in the inside wall next to the slide. At the bottom of the wire guide, the cable exits next to the bottom lower gear rack. If either cable is not properly clamped to the bed side floor, will rub on the lower gear rack and gradually fray. If the wire exposed is the Hall power or Hall sense, the slide will move a few inches and stop displaying a 8 or 9. The slide should work fine in emergency override until you find the frayed section.
Schwintek In-Wall Slideout System Operation And Service Manual
Thor Forums
