Quote:
Originally Posted by Pete'sMH
During a stretch of nice weather just leave them open for a couple of days and maybe facing into the sun if you can. A big box store will carry a wood restoration product that you can use. It’s basically just epoxy that saturates the bad wood to strengthen it. You can inject some of it into the screw holes or use wooden matchsticks soaked in the stuff to fill the holes before redrilling for new screws. Not sure there’s a lot you can do about wavy fiberglass. Good luck.
|
Matchsticks and toothpicks are soft wood and will not hold up. Go to a hobby store a get a thin Burch or Maple dowel. Drill out to the exact size and epoxy them in. Then drill a pilot hole. You may want to add some butyl rubber around the inner edge to make sure that the light assembly is water tight. You can use a flush cutting saw to trim the dowel.