Quote:
Originally Posted by ducksface
They will
Pull the line away from that spring
Add a p clamp, and a self tapper to hold it away
Just about as it says in the recall.
It's pretty obvious from the picture where they'll spend the three minutes.
But
They will likely replace that line due to the wear on it.
|
Need to look at that picture again. The line goes from below the spring up between the spring end and the body frame part to above the spring. Then goes over to the chassis frame and appears to join some wiring bundles in the frame rail itself. There is no just repositioning of an undamaged line. Where it transitions from below to above is that small gap which unfortunately has the back side of the upper spring leaf there too.