I had a 12 LED spare bulb. so I purchased a wire harness for the bulb, I think a 164 wedge type. drilled a 3/16 hole where the top handle is located. ran the wires through and on a separate switch tied that into the hot side of my porch light. I used a two gang switch one for the handle and the other for my 12V battery meter. The hardest part was putting the bulb in the correct way. Also sealed up the handle with a silicone base to keep water out. The porch light is already a 10 amp circuit, no need for another fuse, unless you want to install a separate fuse, that is ok
__________________
|