Thor Forums

[JollyRodgers]

Originally Posted by TyCreek

Third radio sunscreen 3D print turned out great! Perfect fit and doesn't need sticky tape to hold it in place.

First print didn't have enough table contact and a corner lifted before it finished printing. Second print I added flanges to slide behind the radio edge. However the top flange was out of plain with the sides so the top didn't slide behind the radio bezel very well. The worst part is the flange wasn't in contact with the print bed so again, it came loose during the print. Getting that rib flat on the bed was enough to keep this attempt stuck for the whole print.

One comment I have about the plastic sink topic ... when doing dishes, it's quieter than others we've had

Nice print job!