Quote:
Originally Posted by wingnut60
Port,
Not following the wording--"do not have to relieve pressure" But then "it should cause the O-rings to fail"...
Sure is a pain that every time I change the valve position, need to relieve pressure on BOTH sides?
|
You can't edit a post after a period of time - so correcting is a bit of an issue.
The error was on both lines because all I did was a cut and paste since I got the same answer from both Anderson BRASS and the distributer.
Try this.
Quote:
Originally Posted by Porthole
In a conversation with Anderson I was told you do not have to relieve the pressure to turn the valve. It should NOT cause the o-rings to fail by turning the selector with water pressure on the valve.
In a conversation with the distributer for all Anderson products I was told you do not have to relieve the pressure to turn the valve. It should NOT cause the o-rings to fail by turning the selector with water pressure on the valve.
(RNO Distributors https://www.rnodistributors.com/)
|