|
The only thing Invisibrake besides a properly wired 7 pin connector on the back of your rig is a single wire run to the dash and connected to the monitor light...
Looks like etrailer sells that kit for $79... a bit steep for what it is. (Must be the bundle of zip ties... lol
Remind me to remove the current one before selling my MH...
It is an LED, proper resistor matching voltage and LED requirements, and a length of wire. Have to believe you can do this much cheaper.
I'm 1000 miles from my rig - and toad - at the moment so can't check the voltage coming back.
If you buy the kit - attach the socket to connect to toad right by the 7 pin connector - run the single wire to the front and up to the dash, and connect to the LED (other lead goes to ground). Mount in available dash popout.
The rest of the connections (full time power and brake signal) come from the standard 7 pin harness.
__________________
Greg
Not yet retired...
Florida (Michigan transplant)
2014 Hurricane 32A
2000 Infinity (previous)
|
Thor Forums
