No Power to Auto Generator Start

[nkeever]

Magnum ME-AGS Auto Gen Start
Windsport 35M

I am troubleshooting my auto gen start and right off the bat I am not getting power to my panels aut gen start panels. Has any one else had this same issue? I have tried to trace the wires from the panel to the generator and seeing that the red pin 3 never makes it to the generator. Maybe that is the normal but I am also not able to find where it goes.

Thanks ahead of time for any ideas what to check.

[nkeever]

I was finally able to track down the fuse that was blown. This fuse is inline with the red pin 3 cable. Page 16 of the attached pdf

[nkeever]

and the story continues. I was able to run a test once and put the auto gen start into enable mode and the light came on but now after adjusting the settings on the controller I am not able to test or get a green light. I have attached a photo of the auto gen start I have. I can not seem to find any where online of others with the same remote panel installed by my door.

thanks

[16ACE27]

Originally Posted by nkeever

and the story continues. I was able to run a test once and put the auto gen start into enable mode and the light came on but now after adjusting the settings on the controller I am not able to test or get a green light. I have attached a photo of the auto gen start I have. I can not seem to find any where online of others with the same remote panel installed by my door.

thanks

Who cares about others? Go to the source:

https://www.magnum-dimensions.com/au...rt-stand-alone

[HarryS]

It's the same panel I have, but mine is black. Have you tried test on the magnum auto start itself?

[nkeever]

Originally Posted by nkeever

and the story continues. I was able to run a test once and put the auto gen start into enable mode and the light came on but now after adjusting the settings on the controller I am not able to test or get a green light. I have attached a photo of the auto gen start I have. I can not seem to find any where online of others with the same remote panel installed by my door.

thanks

Sorry took a little vacation. I was able to get the auto gen to work after reseating the connection. I am still trying to get the settings correct so I am running the gen at the appropriate times. Thanks for your replies.

[lwmcguire]

Originally Posted by nkeever

Sorry took a little vacation. I was able to get the auto gen to work after reseating the connection. I am still trying to get the settings correct so I am running the gen at the appropriate times. Thanks for your replies.

Glad you figured out the problem

My panel is all digital, curious as to what approximate year yours would be?

[nkeever]

Originally Posted by lwmcguire

Glad you figured out the problem

My panel is all digital, curious as to what approximate year yours would be?

Mine is a 2018