Quote:
Originally Posted by craiglang1
I receive my Dawn 3235 Stainless Steel Sink yesterday and installed it today. Removing the stock plastic sink was pretty easy. There are 3 studs with wing nuts that are under the counter top and need to be removed before sink will come out. I had to take out the top drawer to access one of the wing nuts. Once the wing nuts were off, I unscrewed the "P-Trap" from the sink. Then I just tapped my HYDE putty knife under the lip of the sink and tapped it gently with a hammer. The sink popped up and came out easily. Unfortunately the new Dawn Sink required I enlarge the hole opening. The Dawn Sink came with a cardboard template. I centered it over the existing hole and traced the template with a pencil. The new opening requires you to cut off about 3/8" off the counter top. I used a Craftsman Vibrating Saw to cut the counter top. A Saber Saw (Hand Held Jig Saw) would probably work with a fine tooth saw blade. The counter top is pretty hard to cut. I went thru 2 blades and it took about 30 minutes to cut the larger hole. Dawn Sink fit great, just put some E6000 Adhesive under the rim and set it in place. I had to rotate the hole to line up with the existing P-Trap. Everything fit perfectly. Installed a new stainless sink strainer with plumbers putty and was done. Attached photos show old sink with wing nuts and 2 of the 3 pieces I had to cut out. All tools used and finished sink and under sink. Total project took about 2 hours including about an hour to vacuum up saw dust (fine powder).
|
Hi:
I received this exact sink today. I noticed that there are no mounting brackets for this sink. So, is the stability of this sink due to strong glue and the attachment to the p-trap? After having used it for some time now, did the sink maintain its stability? In other words, did it stay securely in place?
Thank you, V. H.
Thor Forums
