Quote:
Originally Posted by TomAndLindaRogers
I have recently installed a remote control MaxxFan in the forward air vent in our Hurricane 29M. The power for the ceiling lights runs through a square conduit along the forward side of the metal housing you described. The conduit is located just above the ceiling with a piece of metal filling in above it. I drilled a 1/2” hole in the conduit and fished the power wires through it to the command center. The command center is located in the cabinet above the door and that is where I picked up the 12 volt power I needed. It was a challenge to run the wires and install the fan but we love the fan and it was well worth it.
As a side note while working in the command center I discovered that the power for our gray and black tank heaters had never been plugged into the switches. What a surprise!
Tom
|
Tom, Dino - thanks for your detailed replies and photos. This is exactly the info I was looking for.
Question - Tom, where approx. in the metal shroud did you make an opening to locate the conduit, and how large of an opening did you need?
And 2 - Did you try blowing a string through the conduit with a high pressure air nozzle? Some times if there is enough room in the conduit that works well to push through a wire pull string.
And lastly the holding tank heater wiring may be a great place to tie into power if they are 12V as I don't see needing that feature in CA soon.
Thanks Again, Roger