Thor Forums

[axis earl]

Originally Posted by Sli22sli

My Axis 2016 24.1 is stored at my house. I winterized it and had not gone in it for a month or so. I went in recently to start the engine and generator and run it a while. Everything ran well but when I touched the left front wall under the sliding windows - drivers side- by the cup holder - I noticed it was damp. So was the same area on the passenger side. I did not see any signs of water leakage around windows and there was no water on armrests or cup holders- it was just damp. I checked other areas on the walls in the living area, kitchen, bath room, and bedroom and there was no similar dampness(condensation). It had been cold - 15 oF or so in the mornings for a couple of days but it was about 40oF when I started it. I thought it was strange but I wiped the dampness off with a paper towel and the paper towel was not very wet ie not much water involved.

When I went outside I noticed a rectangular area - 6” x 30” -under the sliding windows that had condensation on it. It was on both the passenger and drivers side about in the same area that I had found dampness on the inside. I assume that’s because there is no insulation in that area. There were no other areas on the outside of the Axis that had condensation.

I was wondering if any Axis owners has found similar condensation on the outside and inside under the sliding windows. My best guess is that happened because there is no insulation there.

Exactly the same area where I had high moisture content. Check the different threads on this and you will see the pictures I posted where I paid to have both windows removed to figure this out. The culprit was where the side of the front cap meets the side wall. Poorly caulked screws and the point where these two meet under the top rear portion of the windows allow moisture intrusion. The water was apparently channeling down the aluminum and ending up in the rectangular portion you are identifying.

To further investigate your suspicions, find a business that repairs water damage in homes. They should have an infrared type moisture device. Once you get one, point it at the inside walls underneath the windows. When we did this, it showed "blue" or high moisture in the same rectangular locations. I even purchased a moisture "probe" for around $25 that you stick into the wall and the results aligned with the infrared device.

Hopefully, you can caulk in the locations I pointed out instead of paying $1400-$1500 to removed and replace the windows. By the way, the wood directly under the windows was not moist or damaged by water once the windows were removed. Water intrusion is a real pain and identifying it can be quite vexing. Good luck. Glad you have this forum for reference. I dealt with the problem the hard way.