Installed the locking on board water inlet cover.
Fairly easy job. Ran into a couple easy fix problems. The locking mechanism is on the right side of the box. Didn't realize until I finished the install that a stud was on that side right next to the new opening I cut. Had to remove the cover then drilled a couple small holes and chiseled a grove where the locking bar comes out
I put buytl tape around the inside of the cover and where all the screws go. Still need to put a small bead of silicone caulking a round the cover. I think the buytl tape will stop all water from getting in but better safe than sorry so silicone will be done soon
Jerry