Furnace won't light - simple fix
We have 2015 Thor Challenger with an Atwood furnace AFMD 35141. We spend very little time where temps drop into the 30s. Most times we use the electric fireplace and a small electric heater. Always keeps the cabin temp in the upper 60s to lower 70s without a problem. But on the occasion that we get caught in freezing temps, a functioning furnace is a must to keep the basement (water lines and tanks) from freezing up.
Looked all over the forums and found lots of info. Preparing to pull the furnace, I started taking pics of the wiring to make reinstalling easier. Of course the LED light was giving me the 3 and 3 blinks - telling me I had an Ignition Lockout Fault. So I was tracing the wiring and pull the red wire in the diagram below to shut off the power. What do I find but a RESET/OFF switch!! Nothing mentioned about anywhere else. Well after I pulled the wiring and reset the LED light, then reattaching the red wire, I turned the switch to off and turned the thermostat to a high temp. Nothing. Turned the switch to RESET - BINGO, BANGO, BONGO. Furnace started right up.
Wow - what a simple deal. I had followed all the instruction about turning the gas off, turning the furnace on, letting the blower run and trying to light...etc. Nothing.
Hit the hard RESET switch - fixed.
Just some info for the rest of you.
Note: I apologize that I don't have a better pic of the switch but I'd put it all back together before I remembered to post this. But the attached annotated pic should suffice.
__________________
US Army Retired - Loving The Road Trip
Challenger 37TB
|